2018/August Braindump2go Fortinet NSE7 Exam Dumps with PDF and VCE New Updated! Following are some new NSE7 Real Exam Questions:
1.|2018 Latest NSE7 Exam Dumps (PDF & VCE) 97Q&As Download:
2.|2018 Latest NSE7 Exam Questions & Answers Download:
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.
ike 0: comes 10.0.0.2:500->10.0.0.1:500, ifindex=7….
ike 0: IKEv1 exchange=Aggressive id=baf47d0988e9237f/2f405ef3952f6fda len=430
ike 0: in BAF47D0988E9237F2F405EF3952F6FDA0110040000000000000001AE0400003C0000000100000001000000300101000
ike 0:RemoteSite:4: initiator: aggressive mode get 1st response…
ike 0:RemoteSite:4: VID RFC 3947 4A131c81070358455C5728F20E95452F
ike 0:RemoteSite:4: VID DPD AFCAD71368A1F1C96B8696FC77570100
ike 0:RemoteSite:4: VID FORTIGATE 8299031757A36082C6A621DE000502D7
ike 0:RemoteSite:4: peer is FortiGate/Fortios (v5 b727)
ike 0:RemoteSite:4: VID FRAGMENTATION 4048B7D56EBCE88525E7DE7F00D6C2D3
ike 0:RemoteSite:4: VID FRAGMENTATION 4048B7D56EBCE88525E7DE7F00D6C2D3C0000000
ike 0:RemoteSite:4: received peer identifier FQDN ‘remore’
ike 0:RemoteSite:4: negotiation result
ike 0:RemoteSite:4: proposal id = 1:
ike 0:RemoteSite:4: protocol id = ISAKMP:
ike 0:RemoteSite:4: trans_id = KEY_IKE.
ike 0:RemoteSite:4: encapsulation = IKE/none
ike 0:RemoteSite:4: type=OAKLEY_ENCRYPT_ALG, val=AES_CBC, key –len=128
ike 0:RemoteSite:4: type=OAKLEY_HASH_ALG, val=SHA.
ike 0:RemoteSite:4: type-AUTH_METHOD, val=PRESHARED_KEY.
ike 0:RemoteSite:4: type=OAKLEY_GROUP, val=MODP1024.
ike 0:RemoteSite:4: ISAKMP SA lifetime=86400
ike 0:RemoteSite:4: ISAKMP SA baf47d0988e9237f/2f405ef3952f6fda key 16: B25B6C9384D8BDB24E3DA3DC90CF5E73
ike 0:RemoteSite:4: PSK authentication succeeded
ike 0:RemoteSite:4: authentication OK
ike 0:RemoteSite:4: add INITIAL-CONTACT
ike 0:RemoteSite:4: enc BAF47D0988E9237F405EF3952F6FDA081004010000000000000080140000181F2E48BFD8E9D603F
ike 0:RemoteSite:4: out BAF47D0988E9237F405EF3952F6FDA08100401000000000000008C2E3FC9BA061816A396F009A12
ike 0:RemoteSite:4: sent IKE msg (agg_i2send): 10.0.0.1:500-10.0.0.2:500, len=140, id=baf47d0988e9237f/2
ike 0:RemoteSite:4: established IKE SA baf47d0988e9237f/2f405ef3952f6fda
Which statements about this debug output are correct? (Choose two.)
A. The remote gateway IP address is 10.0.0.1.
B. It shows a phase 1 negotiation.
C. The negotiation is using AES128 encryption with CBC hash.
D. The initiator has provided remote as its IPsec peer ID.
Which of the following statements are correct regarding application layer test commands? (Choose two.)
A. They are used to filter real-time debugs.
B. They display real-time application debugs.
C. Some of them display statistics and configuration information about a feature or process.
D. Some of them can be used to restart an application.
When using the SSL certificate inspection method for HTTPS traffic, how does FortiGate filter web requests when the browser client does not provide the server name indication (SNI)?
A. FortiGate uses the Issued To: field in the server’s certificate.
B. FortiGate switches to the full SSL inspection method to decrypt the data.
C. FortiGate blocks the request without any further inspection.
D. FortiGate uses the requested URL from the user’s web browser.
What global configuration setting changes the behavior for content-inspected traffic while FortiGate is in system conserve mode?
View the exhibit, which contains the output of a BGP debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
A. For the peer 10.125.0.60, the BGP state of is Established.
B. The local BGP peer has received a total of three BGP prefixes.
C. Since the BGP counters were last reset, the BGP peer 10.200.3.1 has never been down.
D. The local BGP peer has not established a TCP session to the BGP peer 10.200.3.1.
View the exhibit, which contains the output of a web diagnose command, and then answer the question below.
Which one of the following statements explains why the cache statistics are all zeros?
A. The administrator has reallocated the cache memory to a separate process.
B. There are no users making web requests.
C. The FortiGuard web filter cache is disabled in the FortiGate’s configuration.
D. FortiGate is using a flow-based web filter and the cache applies only to proxy-based inspection.
View the exhibit, which contains a partial output of an IKE real-time debug, and then answer the question below.
Based on the debug output, which phase-1 setting is enabled in the configuration of this VPN?
View the global IPS configuration, and then answer the question below.
Which of the following statements is true regarding this configuration?
A. IPS will scan every byte in every session.
B. FortiGate will spawn IPS engine instances based on the system load.
C. New packets will be passed through without inspection if the IPS socket buffer runs out of memory.
D. IPS will use the faster matching algorithm which is only available for units with more than 4 GB memory.
View the following FortiGate configuration.
All traffic to the Internet currently egresses from port1. The exhibit shows partial session information for Internet traffic from a user on the internal network:
If the priority on route ID 1 were changed from 5 to 20, what would happen to traffic matching that user’s session?
A. The session would remain in the session table, and its traffic would still egress from port1.
B. The session would remain in the session table, but its traffic would now egress from both port1 and .
C. The session would remain in the session table, and its traffic would start to egress from port2.
D. The session would be deleted, so the client wo
View the exhibit, which contains the output of a diagnose command, and then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
A. FortiGate will probe 22.214.171.124 every fifteen minutes for a response.
B. Servers with the D flag are considered to be down.
C. Servers with a negative TZ value are experiencing a service outage.
D. FortiGate used 126.96.36.199 as the initial server to validate its contract.
What does the dirty flag mean in a FortiGate session?
A. Traffic has been blocked by the antivirus inspection.
B. The next packet must be re-evaluated against the firewall policies.
C. The session must be removed from the former primary unit after an HA failover.
D. Traffic has been identified as from an application that is not allowed.
1.|2018 Latest NSE7 Exam Dumps (PDF & VCE) 97Q&As Download:
2.|2018 Latest NSE7 Study Guide Video: